[DannoXYZ]

Items yet to do:

- manually spin motor and verify all valves move together
- compression test
- install factory CR8E plugs
- remove shims/washers on needles

- stumbling at 1/4 and 1/2 throttle?
- duct-tape over 50% of each pod-filter's surface area. Does it rev ok at 1/2 throttle? Full thottle?

- measure battery voltage with bike off and with bike running
- unplug both red wire from both coils, key ON, what is voltage at each red wire?
- wiggle and yank on various parts of harness wires. Does voltage at each red wire change?
- key OFF, measure resistance between two red coil wires
- measure resistance between each red coil wire and chassis ground