ninjette.org - View Single Post

maverick9611 · May 25th, 2020, 04:50 AM

it starts and idles normal.
as soon as throttle is open #1 cylinder starts to load and sound erratic.
difficult to reach mid throttle

if i keep opening throttle, i get intense smell of gas.
bike usually dies if throttle is opened.
since i got bike home. the symptoms have stabilized to just bad/unrideable. been on the stand since 03/19

i have pulled the plug on cylinder #1/it almost looks fouled.

we ruled out ignitor,coils,carbs,fuel delivery,air, has new battery.
what about safety switches?should i jumper them?
compression good on both cylinders too.
camshaft position sensor changed out also.
if i ran jumper wire from ignitor to each respective coil
green with 2 gray dots(cylinder#2) and black with 2 gray dots(cylinder#1) and no change occurred. would not this eliminate ignitor to coil test as ok?
damn sounds ignition related but how and where to look. or do i just buy a new wiring harness?

May 25th, 2020, 04:50 AM	#111
maverick9611 "a legend in my own mind" Name: maverick9611 Location: Augusta,Georgia Join Date: May 2017 Motorcycle(s): 2015 moto guzzi norge(brownie),2020 aprilia dorsoduro, Posts: A lot. MOTM - Feb '18	it starts and idles normal. as soon as throttle is open #1 cylinder starts to load and sound erratic. difficult to reach mid throttle if i keep opening throttle, i get intense smell of gas. bike usually dies if throttle is opened. since i got bike home. the symptoms have stabilized to just bad/unrideable. been on the stand since 03/19 i have pulled the plug on cylinder #1/it almost looks fouled. we ruled out ignitor,coils,carbs,fuel delivery,air, has new battery. what about safety switches?should i jumper them? compression good on both cylinders too. camshaft position sensor changed out also. if i ran jumper wire from ignitor to each respective coil green with 2 gray dots(cylinder#2) and black with 2 gray dots(cylinder#1) and no change occurred. would not this eliminate ignitor to coil test as ok? damn sounds ignition related but how and where to look. or do i just buy a new wiring harness? __________________________________________________ "trying not to get old" Last futzed with by maverick9611; May 26th, 2020 at 06:33 AM.