[Ghostt]

That is my goal, if not cheaper, a better replacement part to the OEM bar. These would fit the OEM risers, and be a bolt on replacement part.

The OEM bars are cheap, and bend from just a drop, I'm looking for a stronger part, that would take abuse, without bending so easley.

As far as eliminating the bar ends, I don't know about that. Personally I'm going to keep my custom stainless steel bar ends, they are extra heavy, and eliminate a lot of the bar buzz.

Bar buzz is a personal choice, one could try them out without the ends, and make their choices afterwards. I will be tapping them for the ends, the choice would be up to the individual wether or not to use them.