Quote:
Originally Posted by jkv45
If I'm following your question correctly - yes.
Test for power coming into and out of the switch with it is activated. Use tape or a rubber band on the front brake lever to hold it "on", and find something for the rear brake lever that will do the same, then follow the power towards the light.
|
I believe I fixed the issue. The Red wire leading into the License Plate light was frayed, so I patched it with electrical tape and it seems to be working. I guess from looking at the electrical diagram, it wasn't apparent to me that a frayed wire for the license plate light would cause the brake light not to work. I will check before each ride.
Now, in loo of using screws, the previous owner used zip-ties to secure alot of stuff. Is there a spec sheet somewhere that calls out screw sizes for the fairings, seat, and back compartment?
Thank you all for your help!