Quote:
Originally Posted by verboten1
So, ninja 600 swingarm like my old one, and you just have to cut come material off the ends? Did you use the 600 linkage. Or the 250?I'm trying to throw a different swingarm on my bike for a wider wheel. May have to get another one!
|
Also when you narrow the 600 swinger there may be enough room to press in the 600 stock bearing but no room for the seals. I will look for maye a narrower bearing that may have a built in race to fit the 250 hardware.
I used the ninjette linkage just need to get some washers for the bottom dogbones mount. I have non -stock dogbones I am sure the prior owner lowered the bike.
Going to see if i can use the ninjette brake caliper since it's newer and smaller. Rear wheel axles seem about same thickness between the 250/600.