Quote:
Originally Posted by jkv45
Back in the day we used Ninja 250 bars on our race Ninja 500 because they were lower. The inside needed to be opened-up because the 500's tubes were larger, but other than that they bolted on.
So if you used a set of EX/Ninja 500 bars they would be higher, but you may want to come up with some type of shim to get a snug fit on the smaller 250 fork tubes.
|
Wouldn’t the bars still be 7/8ths on both? So couldn’t you just swap all the controls from the 250 bars to the 500 bars and just bolt them to the forks?
Also one guy online used to make risers for the 250, the website is still up and you can place an order and send money, but the parts never show up and there is no response from the site. They are expensive at 100 bucks for aluminum blocks to adjust bar height.