Dear @
gantt,
Thank for your reply.
Yes, i want to read the boost pressure, but before i don't know what is the right position to connect the pipe of gauge, i intended connect it to the plenum. Is it ok for pressure reading of gauge?
About the MAP sensor, yes, Manifold Absolute Pressure, i used a 2.5bar MAP sensor in order to use Power Commander 5 tune based on this sensor data. I also got advice from Jerry Schoenauer from Dynojet about this application. But the question that where is the position to install the sensor, i think about the position after the butterfly of Throttle Body.
Could you please look to the below diagram, advice me more with thank.