ninjette.org - View Single Post

Momaru · January 17th, 2012, 01:22 AM

Not to be overly crass, but if you read through the DIY that the OP made and linked in this very thread, post #27, you'll find another good answer.

It boils down to soldering (or crimping) the wiring from the shutters (both) on the projector into a single H4 male plug, to jack directly into your OEM high-beam wiring in place of the stock bulb. It's an H4 connector on the harness, NOT an H7 as the OP used; if you go that route, you have to use the adapters that sit between the OEM bulbs and the harness.

January 17th, 2012, 01:22 AM	#100
Momaru ninjette.org certified postwhore Name: Paul Location: Roanoke, VA Join Date: Jun 2009 Motorcycle(s): 2008 Candy Plasma Blue 250R Posts: A lot.	Not to be overly crass, but if you read through the DIY that the OP made and linked in this very thread, post #27, you'll find another good answer. It boils down to soldering (or crimping) the wiring from the shutters (both) on the projector into a single H4 male plug, to jack directly into your OEM high-beam wiring in place of the stock bulb. It's an H4 connector on the harness, NOT an H7 as the OP used; if you go that route, you have to use the adapters that sit between the OEM bulbs and the harness. __________________________________________________ Proud member of the Blue Army