ninjette.org - View Single Post - Throttle cable Re Install after putting carbs back

DannoXYZ · October 2nd, 2019, 12:58 PM

You're welcome!
Those barrel cable-ends are typically moulded on. Something like this may work. Measure diameter of other cable end to find exact size needed.

http://www.myronsmopeds.com/category/cable-parts/
https://store.bevelheaven.com/Cables...rew-5.4mm-DIA/
https://www.ebay.com/itm/132337617406

Here's innovative way to re-mould cable-end using solder.

October 2nd, 2019, 12:58 PM	#5
DannoXYZ ninjette.org certified postwhore Name: AKA JacRyann Location: Mesa, AZ Join Date: Dec 2011 Motorcycle(s): CB125T CBR250R-MC19 CBR250RR-MC22 NSR350R-MC21 VF500F CBR600RR SFV650 VFR750F R1M ST1300PA Valkyrie-F6C Posts: A lot. MOTY - 2018, MOTM - Nov '17	You're welcome! Those barrel cable-ends are typically moulded on. Something like this may work. Measure diameter of other cable end to find exact size needed. http://www.myronsmopeds.com/category/cable-parts/ https://store.bevelheaven.com/Cables...rew-5.4mm-DIA/ https://www.ebay.com/itm/132337617406 Here's innovative way to re-mould cable-end using solder. Link to original page on YouTube. Last futzed with by DannoXYZ; October 2nd, 2019 at 03:37 PM.