Quote:
Originally Posted by Dizzy
With the stack of plates? Well it started doing this after the clutch was stuck and it lostened up and let me shift and then when I shift into 1 it just revs when I let of the clutch revs doesn't die doesn't move forward or anything
|
ah, this sounds like spring/pressure-plate isn't moving inwards and squeezing stack together.
1. did you put 2x clutch plates with wider blocks as 1st and last plates installed?
2. did you line up dimples on spring/pressure plate with basket? Even though there's multiple splines, the spring plate can only be installed in 2 possible orientations.
From the manual:
Quote:
"Fit the spring plate back into place, aligning the mark on the plate with the mark on the clutch hub."
Caution: Misalignment of the spring plate can cause clutch drag (when it is disengaged), or clutch slipping.
|
Earlier, your problem with clutch dragging and not fully releasing. Now it's not engaging at all.