ninjette.org - View Single Post

jkv45 · April 25th, 2019, 06:21 AM

I also posted this on another forum -

I'd probably replace it with a good used one.

No need for a new one, they typically aren't going to wear out or get damaged. Cross-check part numbers, but the 300 valve cover may be the exact same as the "New Gen" 250 valve cover - so they would be a dine-a-dozen and easy to get used. Even if not, there should be plenty of used 300 covers out there.

You gasket should be fine, as it's rubber and reusable.

This video showing valve cover removal is for the 250, but should be the same or very similar -

Link to original page on YouTube.

April 25th, 2019, 06:21 AM	#2
jkv45 Rev Limiter Name: Jay Location: WI Join Date: Jul 2013 Motorcycle(s): '06 SV650n, '00 Derbi GPR, '64 CA77 Dream 305, '70 CL450 Scrambler, numerous dirt bikes Posts: A lot. MOTM - Jun '18, Oct '16	I also posted this on another forum - I'd probably replace it with a good used one. No need for a new one, they typically aren't going to wear out or get damaged. Cross-check part numbers, but the 300 valve cover may be the exact same as the "New Gen" 250 valve cover - so they would be a dine-a-dozen and easy to get used. Even if not, there should be plenty of used 300 covers out there. You gasket should be fine, as it's rubber and reusable. This video showing valve cover removal is for the 250, but should be the same or very similar - Link to original page on YouTube.