ninjette.org - View Single Post

DannoXYZ · January 8th, 2018, 09:45 AM

I was researching this months ago when I found frayed clutch cable. No one made quality cable with teflon-lined housing. I ordered one MotionPro and one cable through Ali. Both exactly the same. I suspect that’s where MotionPro sources their cables.

In the end, I went with used OEM cable from breakers and have both MotionPro and Chinese cable as spares in my toolbox. Be careful when installing, set adjuster rotation so that its slot is aimed up or down so the cable doesn't rub on sharp edges of teeth.

On back-burner, but I'm still looking for good cable with teflon-lined housing. May adapt one from different bike that's close enough. There are also DIY kits with unattached end. Trim to length and crimp & solder barrel-end on.

January 8th, 2018, 09:45 AM	#4
DannoXYZ ninjette.org certified postwhore Name: AKA JacRyann Location: Mesa, AZ Join Date: Dec 2011 Motorcycle(s): CB125T CBR250R-MC19 CBR250RR-MC22 NSR350R-MC21 VF500F CBR600RR SFV650 VFR750F R1M ST1300PA Valkyrie-F6C Posts: A lot. MOTY - 2018, MOTM - Nov '17	I was researching this months ago when I found frayed clutch cable. No one made quality cable with teflon-lined housing. I ordered one MotionPro and one cable through Ali. Both exactly the same. I suspect that’s where MotionPro sources their cables. In the end, I went with used OEM cable from breakers and have both MotionPro and Chinese cable as spares in my toolbox. Be careful when installing, set adjuster rotation so that its slot is aimed up or down so the cable doesn't rub on sharp edges of teeth. On back-burner, but I'm still looking for good cable with teflon-lined housing. May adapt one from different bike that's close enough. There are also DIY kits with unattached end. Trim to length and crimp & solder barrel-end on. Last futzed with by DannoXYZ; January 8th, 2018 at 11:40 AM.