Quote:
Originally Posted by tjkamper
Don't know why they are not in the DIY's other than if you are simply installing an exhaust it is probably not necessary, plus it is probably not needed at high elevation.
Here is a diagram (not very good but it might help you locate the pilot jets) Part number 92064
From my experience, the pilot jets are a PITA to take out without pulling the carbs. It can be done, but you need a thin short flat head screwdriver.
|
Yeah I saw that diagram in my Service Manual. They arent in the "rejet without removing carbs" diy. Not even mentioned. With the Milwuakee Offset screwdriver I should be fine removing them. I had no problem with the main jets.
Thanks again for all your help. I will tackle this on Sat and post here.