I took a 50 mile ride this morning on my bike and all was well. I noticed that the clutch seemed to be releasing a little late for my tastes. I had replaced the clutch cable a week or so ago. No problems going into gear or jumping when releasing the clutch.
When I got home, I adjusted the clutch slack on the clutch lever on the handle bars. Not any better. I then adjusted the cable down at the clutch arm on the engine.
After that, the bike now immediately dies as soon as I start to release the clutch! It is as if I flipped the kill switch! I can start the bike with the clutch pulled in with no problem, but as soon as I start to release the clutch even a fraction of an inch, the engine dies.
No problem with idle or reving the engine with the clutch pulled in or in neutral.
What did I do wrong!?!