Bottom end back together with new seals and painted, + clear coat (engines were painted blue on these bikes from the factory)
frame cleaned up sanded and painted = clear coat
and linkage got new bearings and seals.
Found a crack in the swing arm pivot unfortunately, had to pick up a used on one ebay, should be here in a few days. This is what i was talking about when i said replacing chassis parts. This is an extra $60 i didn't want to spend. I might have cracked it myself when i was getting the old rusty seized bearings out. Normally i press them out but i was being lazy and kind of rushing so i pounded them out.
Only other issue i have noticed is there is a missing spoke on the rear wheel, not sure where i can find just one spoke.... ill figure it out.
__________________________________________________
I love the smell of burning pre-mix in the morning
I don't think I'm a lot dumber than you thought that I think that I thought I was once.
Last futzed with by subxero; March 21st, 2017 at 06:42 AM.
|