|
take a piece of 80 grit sandpaper and wrap it around your finger and get in there and make that all shinnie metal !
once you get the big hunks off you can switch to 220 grit or something...
... then put oil on it or grease
probably ought to clean up the top clamps as well....
....
get that gas out of the bottom end asap as it will harden the crank seals if you leave it in there too long.... re fill the crank case with oil immediately.
or it will flash rust on you....
myself I would re fill it up to the top where the gas was at.... turn it through by hand a few times then drain it back down to the proper level....
that's probably not all that necessary, but I think I'd do that.
....
Bob....
__________________________________________________
Its too late when you've gone too far !
|