Quote:
Originally Posted by BonelessSugar
I snapped one of the super thin screws holding the clutch sensor onto the clutch handlebar housing (these probably aren't the terms). Need to get a new one anyways because I don't have something to TIG the inside to fill and then drill and tap the hole. If there's another solution I could do (maybe use the steelstik I have for the carb) to fix that? Lemme know your thoughts. Might swap to shorty levers, too, since I don't wanna use this shaved lever.
|
You can try filling and tapping. What I've done in this case is drill and tap for next size larger thread M6, and slightly enlarge hole in switch.