Quote:
Originally Posted by cbinker
what made you decide to run that throttle that direction?
|
What do you mean? Are you referring the the angle of where the MotionPro is mounted?
The angles of the clip ons and the MotionPro are not set just yet. These positions were set temporarily as baselines. The oil pan is being held up by a jack at the moment and waiting to install the rear shock and hook the linkage all up before I can sit on the bike and figure a perfect setup for the clip on and throttle positions.
In addition, I more than likely will be removing the stock start/stop switch and installing a smaller switch because that is holding me back from adjusting the MotionPro properly.
I hope that's the info you were looking for