Bead breakers are pretty cheap on ebay, but before I had one of those I just used a big c-clamp I had. A set of 3-4 motion pro spoons and up to 4 rim guards, but I will say 2 rim guards is not enough.
Also, an interesting note: baby ninjas are harder to do than supersports. Not sure why, but I think it's because the little valley where the bead rests as you are spooning it off the other side is a lot smaller. Tire changes on my 675R were much easier.
You need a 125+ PSI high volume compressor to seat the bead most of the time. Also don't forget bead lube, and don't use windex like some people say. I use Xtra Seal 1Gal Slik Bead Lube. I like that stuff better than the grease based lubes because the tire is lest likely to have a bead leak later.
__________________________________________________
Ninja 300 - CCS Ultralight Thunderbike Racing
I want to "like" your post but I can't due to forum rules. Sorry.
|