ninjette.org - View Single Post - Seat cowl - installation and replacement rubber grommet

Sound Wave · April 19th, 2009, 06:05 PM

the rear grommet is hillman part number 139377. it is a 31/32" outer diameter and a 1/2" inner diameter. found it at lowes in the nuts and bolts section in the drawers.

for me, i just used some rubber caster looking thingys in the front. i stacked 3 of them up on each side. i will try to find my packaging.

edit: thanks guys.

edit again: corey beth.. yeah it fits better because the stock ones are too high. i bet it wobbles now though, huh? so you gotta bend the bracket as much as you can and have it still catch the lock, and you gotta put as little rubber stopper as you can without it wobbling. kind of a balancing act.

April 19th, 2009, 06:05 PM	#84
Sound Wave Ramen Rider Name: Gary Location: Honolulu, Hawaii Join Date: Jan 2009 Motorcycle(s): 2015 BMW R1200R, 08 Honda VFR800A (sold), 09 Ninja 250R (sold) Posts: A lot.	the rear grommet is hillman part number 139377. it is a 31/32" outer diameter and a 1/2" inner diameter. found it at lowes in the nuts and bolts section in the drawers. for me, i just used some rubber caster looking thingys in the front. i stacked 3 of them up on each side. i will try to find my packaging. edit: thanks guys. edit again: corey beth.. yeah it fits better because the stock ones are too high. i bet it wobbles now though, huh? so you gotta bend the bracket as much as you can and have it still catch the lock, and you gotta put as little rubber stopper as you can without it wobbling. kind of a balancing act.