Right Turn Signals Staying Solid
I bought this bike about a month ago, 2010 Ninja 250, the guy had dropped it at one point and the front right turn signal was broke off. My new ones just came in and I figured once I hooked up the new front right signal I would be good to go. I hooked up the front right one, and both on the right side just stays solid. The left works fine as always. I even unhooked the old rear right one and hooked up a new one, still staying solid. I tried putting slight bends in the prongs on the connectors, I tried wiggling all the wires. What else can I do?.. any ideas? If it was the relay or fuse was bad then none of the turn signals would be working, correct? This is driving me nuts. Thanks.
|