View Single Post
Old October 22nd, 2018, 10:13 AM   #78
GreasedLissik
ninjette.org member
 
Name: silentlyloud
Location: South Bay LA
Join Date: Jan 2018

Motorcycle(s): 2007 Ninja eX250

Posts: 49
Good morning everyone, so I was able to install the 300 motor in the 250, I did use the 300 front mount bracket, the coil o plugs, stock exhaust, stator and magneto. I did start it up but i only did so twice, it seem that i have to check valve clearance and shim them, because there is a ticking noise. I did extend about 5 wires to make this work

And my biggest problem is that clutch needs to be held down to start the bike(which has never happened before) and when i go to release the clutch the bike died, i have today off and will check to see if my sensor is working after i shim the valves
GreasedLissik is offline   Reply With Quote