Thread: '92 rebuild
View Single Post
Old September 7th, 2021, 02:32 PM   #19
BonelessSugar
ninjette.org member
 
Name: Cashby
Location: Maine
Join Date: Sep 2021

Motorcycle(s): EX250-F x 3, TW200, NPS50

Posts: 98
I use my soldering kit with rubber to melt sections into the broken plastic bits of the fairings. This kit. It makes it a little brittle, but way better than nothing. I usually sand it afterwards. Have about 10 spots to do, mostly done with this first one.



Punched out the front foot peg, still having a hard time finding a replacement for less than $20 for one OEM peg. Any recommendations for an aftermarket set?


Punched out the rear peg because it was stuck. Lubed it up and cleaned up rust on the inside a little (not a lot). Works just as well as the other side, now.



Absolutely no idea what this is. It's part of the throttle, but was never connected. The throttle is taken apart right now and I'm having a tough time putting it back together at the handle.


This right handlebar looks bent.


Fork seals are worse than I thought. No leaks yet, though.
BonelessSugar is offline   Reply With Quote