Quote:
Originally Posted by Onekallo
Stupid question but now how do I get the idle back?
Can’t remember where it was set. Let’s say I give it full choke this morning and it fires up but revs at 5k; is that normal? Then I would leave idle setting as is and as it warms up remove choke?
Sorry I am excited you believe it is almost close, but want to make sure I can get it back there.
Thanks so much.
Side bar, choke is smooth and does come on and off. Cables move freely and so does actual valve from a quick inspection last night.
|
The way my bike starts: Choke to full open, she fires up runs at low(1k rpms) , but in a couple of seconds the tach goes to about 5-6k, I lower it to about 3k and start riding. The rev would stay at 3k on the stops when I roll of the throttle. I ride like that for 1-2kms and then close the choke. The revs would go down to the preset value. At the time when the coolant temp gauge shows at least 1/3rd I double check the revs when the throttle is off and adjust if necessary. Mine is set at about 1.3-1.4k