Quote:
Originally Posted by DannoXYZ
Notice that there's only one way the brake bracket can fit. What part did you loosen and adjust?
The only thing that makes sense is you got spacer 92027A reversed. Then it would cause:
1. Wheel to stop spinning, because space flange would squeeze seal instead of pressing on brake caliper bracket
2. Wheel would sit further to left
3. In order for brake disc to fit, wheel would lean to right
4. Under load, wheel would wobble due to loose torque needed to allow wheel to spin
You need to replace seal 92049, it's most likely damaged. This will allow dirt in and damage wheel bearing quickly and need replacing in less than a couple months.
 |
Bracket 43034 bolts into an arm at the top, i loosened that bolt