ninjette.org - View Single Post - IGNITION SWITCH BYPASS-To-3pSt

DannoXYZ · February 27th, 2021, 11:01 AM

Ok, here's how you want to have your switch wired:

There's 3 separate input wires going through different fuses and 4 outputs.
Grey ignition-wire should share same output-terminal as brown wire going to fuse-box.

You want to test for power on harness-side of ignition-switch connector by back-probing terminals. Should match state shown in table above.

February 27th, 2021, 11:01 AM	#12
DannoXYZ ninjette.org certified postwhore Name: AKA JacRyann Location: Mesa, AZ Join Date: Dec 2011 Motorcycle(s): CB125T CBR250R-MC19 CBR250RR-MC22 NSR350R-MC21 VF500F CBR600RR SFV650 VFR750F R1M ST1300PA Valkyrie-F6C Posts: A lot. MOTY - 2018, MOTM - Nov '17	Ok, here's how you want to have your switch wired: There's 3 separate input wires going through different fuses and 4 outputs. Grey ignition-wire should share same output-terminal as brown wire going to fuse-box. You want to test for power on harness-side of ignition-switch connector by back-probing terminals. Should match state shown in table above. Last futzed with by DannoXYZ; February 28th, 2021 at 10:21 PM.