View Single Post
Old August 18th, 2017, 01:10 PM   #40
VaFish
ninjette.org certified postwhore
 
VaFish's Avatar
 
Name: Tom
Location: Northern Virginia
Join Date: Jul 2015

Motorcycle(s): 2001 Ninja 250, 2019 Harley Ultra Classic, 2001 Suzuki SV650

Posts: A lot.
MOTM - Jan '16
Quote:
Originally Posted by gitter View Post
hey guys, its been a few days, finally had time to pull the harness and split it open.

Found that the black (signal wire for the tach) and the brown/black (im assuming ground for tach, gas gauge, and temp light) were worn through and touching, close to where the black wire splits into two wires ( to go to tach and left coil, respectively)

I dont want to jinx it but I'm pretty sure that was my problem. At this point do i just wrap the bare spots with tape and then wrap the harness back up?
To test that it fixes the problem yes. But you will eventually get problems there again. Best bet is solder and shrink wrap.
VaFish is offline   Reply With Quote