don't remember the name. it was right off Mesa Blvd in the east valley. little bitty place. Been about 7 years since I lived there...All he did was take his very large press, drop the tubes in some V-Blocks and using dial indicator find high spot. with v-blocks on either side of bend out about 8" either side press high spot down, then measure, again...then he had this tube roller he would but them in and roll them for final.
Gotta be more than one place that can do it...
__________________________________________________
Thanks to: , DUNLOP, WHOOPIE RACING, 995 PAINTWORKS, South Austin Motorcycles
|