ninjette.org - View Single Post - WTB a set of of wheel .. plus.. for ninja 250 track

Qomomoko · April 30th, 2015, 05:41 AM

thanks,

I am confused on pulling the bearings out of the front rim as it is two bearings, one on each end. I could tap the bearing out with a long tap/flathead but I was looking for a piece of wood. I imagine the tool somehow fits through the inside of the bearing and reaches the other side of the other bearing and is flat against it in at least three points and then I would push it/hit it..

the tool you posted, I suppose I am not still clear on how it work.

I'll keep searching and such..

the needle bearings in the swing arm seem even harder as they inside of them is flush with the swing arm.

April 30th, 2015, 05:41 AM	#45
Qomomoko ninjette.org guru Name: Luis Location: Miami Join Date: Sep 2014 Motorcycle(s): 1995 Ninja 250, 2005 R6, 2002 Ducati Monster S4 Posts: 250	not really follow how its done/works thanks, I am confused on pulling the bearings out of the front rim as it is two bearings, one on each end. I could tap the bearing out with a long tap/flathead but I was looking for a piece of wood. I imagine the tool somehow fits through the inside of the bearing and reaches the other side of the other bearing and is flat against it in at least three points and then I would push it/hit it.. the tool you posted, I suppose I am not still clear on how it work. I'll keep searching and such.. the needle bearings in the swing arm seem even harder as they inside of them is flush with the swing arm.