Quote:
Originally Posted by Jeepster1000
Just took a quick measurement and the 1 connection with wire was 12.6V 2 without wire was 6.9V...
|
great work!
This confirms grey wire is soldered to wrong teminal.
1. carefully unsolder grey wire from#1. Be careful not to disturb resistor. After wire removed, add a little more heat & solder so entire copper terminal is coated smoothly with solder
2. install grey wire on #2, being careful not to disturb resistor.
Bike should now start.*
* assuming carbs are factory-fresh clean. Depending upon how long it sat dormant, carbs may not be delivering sufficient petrol.