Quote:
Originally Posted by Bob KellyIII
HAY ! I think I got it !
I went out there and pulled the air screw and dug out the probe set i had bought for the Ninja... ( i haden't tried that on the carb yet) took the smallest wire of the set ( looks like a long torch tip cleaner set) and tried to poke that through the jet at first it was no go but I kept poking at it and it finally went through...
|
Heh, heh... just when you think when you've got it all cleaned!!! It's like those Ginsu knife commercials from '80s...
"BUT WAIT!!! There's MORE!!!!"
Try working from other end as well. Poke out bleed-holes from carb-venturi. Bend some wire 90-degrees 10mm from end and use that on each of bleed-holes. This was final "Ah HAH" moment on many carbs for me. Saved me from forfeiting an entire race-weekend once.