[jkv45]

Originally Posted by moviepilot

Does anyone know the Torque value in Lbs for these Engine Bolts?

This is what I've found - https://faq.ninja250.org/wiki/Checki...ne_mount_bolts

"Engine mount bolts are one thing that will loosen up with time and vibration. This can happen in as little as 7500 miles, so it would be a good idea to check the torque a couple times a year, or at least as part of the winterization process. You should also check the other fasteners periodically, too.

There are only 3 mount bolts, and they all have a torque value of 24 ft-lbs and use a 14mm socket. There are two at the rear and one at the front of the engine. Use red (high-strength) thread locking compound on these bolts to prevent them from loosening again so quickly, although since you'll probably be pulling the front one when you adjust the valves, just use blue Loctite on that one.

The rear two bolts both have nuts on them. The nuts are located on the right side of the bike."

They suggest Red threadlocker, but Blue (medium) is usually adequate. I like the gel/paste compound instead of the liquid.