Quote:
Originally Posted by spent_too_much
Any suggestions on filling in this void? It is where the right hand side turn signal bolts on. The previous owner made a faux carbon fibre plate, bolted over it. Not a bad job, but not my style.
I have another lower engine fairing ( disfigured due to heat? ) to use for bits of plastic. I thought I might try to solder weld bits together, then apply a coat of epoxy, then sand to shape.
This pic is upside down. It is the main upper fairing.
|
After cleaning up the edges a bit, I would attach a piece of paper flush on one side of the hole with spray adhesive or some other glue, fill in the void with ABS cement, and then sand.