Quote:
Originally Posted by baxtc1
Sounds like too much pad/piston travel. Try taking the caliper of the disc and push the pistons out a little using the brake lever, (make sure not to go too far and push them out of the caliper) then spread the pads enough to go over the disc. Should be an improvement.
|
I did this several times, gently without wood wedges between the pads and hard with the wedges in place.
I did notice that each piston seemed to slide easily, but if you remove pads and then gently pressurize caliper one piston begins moving long before the other. Sticky pistons that need to be replaced?