ninjette.org - View Single Post

bgraff1 · August 15th, 2010, 10:26 AM

I am doing a plate replacement on my '99 ninja 250- and your post has been very helpful. However, I am stuck at the point where I have to attach the cable to the swing arm. The cable is about a quarter inch short of the attachment on the arm and I can't figure a way to close the gap. You said to attach it before swinging the arm up, but the cable is much too short for that.

Any suggestions?
bob

August 15th, 2010, 10:26 AM	#24
bgraff1 ninjette.org newbie Name: bob Location: lockport Join Date: Jul 2010 Motorcycle(s): NINJA 500, NINJA 250, KZ750 Posts: 2	I'm stuck I am doing a plate replacement on my '99 ninja 250- and your post has been very helpful. However, I am stuck at the point where I have to attach the cable to the swing arm. The cable is about a quarter inch short of the attachment on the arm and I can't figure a way to close the gap. You said to attach it before swinging the arm up, but the cable is much too short for that. Any suggestions? bob