Quote:
Originally Posted by Jayden353
4. cant check voltage while turning cause i cant get it to turn on anymore.
|
Something's wrong because with resistor removed and wiring restored to factory config, engine should still crank over using aftermarket ign-switch (even if it doesn't start). Undo whatever you did to get back to when engine would crank and turn over, but not start.
Verify new switch is connected to perform as follows:
Key ON
white <-- connected --> brown
red/blue <-- connected --> red
white/blk <-- connected --> white/grn + gry
Key PARK
white <-- connected --> red
white/blk <-- connected --> white/grn
No crank might also be issue with interloc safety switches.... Starter won't crank if interlocs aren't set correctly.