ninjette.org - View Single Post - DIY - Replace the '08+ CDI (Ignitor) with the '88-94 CDI

camaroz1985 · August 28th, 2009, 08:41 AM

I was hoping you would correct that, the seal should be crimped under the taps of the terminal. This ensures the seal won't back out with vibration, or strain on the connector.

I would advise that you crimp it with the seal under the tabs (I design these for a living, so I have some experience

)

August 28th, 2009, 08:41 AM	#63
camaroz1985 ninjette.org certified postwhore Name: Ryan Location: Carlisle, PA Join Date: Nov 2008 Motorcycle(s): 2008 WR250R, 2006 Ural Raven (Sold), 2009 Versys Green (Sold), 2008 Ninja 250R Green (Sold) Posts: A lot.	I was hoping you would correct that, the seal should be crimped under the taps of the terminal. This ensures the seal won't back out with vibration, or strain on the connector. I would advise that you crimp it with the seal under the tabs (I design these for a living, so I have some experience )