View Single Post
Old April 12th, 2021, 08:21 PM   #3
MauR
ninjette.org member
 
MauR's Avatar
 
Name: Mauricio
Location: Mexico City
Join Date: Aug 2015

Motorcycle(s): 250R

Posts: 84
Hello!!

If a recall correctly you need one 9Pin Connector and one 2Pin Conector. Don't remember if male or female connectors but they are cheap so maybe you could buy both of them.

Here is the link http://www.cycleterminal.com/110-connectors.html

And a picture of the connector in my bike. I used a cutted harness because the connectors were lost in the mail. By this picture it looks like the connectors were MALE.

Also a picture of the speed sensor mounted in the wheel.


My RX2 had 2 temp sensors and one speed sensor... so with the mounting plate it was all done... I recommend using carbon fiber for the plate. Acrylic didn't last

Sorry I don't have more pictures of the process

Hope this helps
Attached Images
File Type: jpg DSC_0005.jpg (82.6 KB, 13 views)
File Type: jpg DSC_0006.jpg (66.6 KB, 11 views)
MauR is offline   Reply With Quote