View Single Post
Old July 20th, 2021, 12:36 PM   #1
mgentz
Board Member
 
Name: ...
Location: WI
Join Date: Dec 2011

Motorcycle(s): 250R (street), 250R (dirt)

Posts: A lot.
FS 2009 Kawasaki Ninja 250

Currently located around Milwaukee WI, but I am moving to the St. Louis MO area soon and could deliver along that route.
17,XXX Miles
Clear and Clean Title
No Accidents and never down
Maintained EXTREMELY well

All stock and spare parts that I have will be given to the buyer as well. There are way too many to list, but I can think of: Stock carbs, spare sprockets, spark plugs, gaskets, rearsets, some crank bearings, other random bearings, some bolts, K&N pod filter, many jets and much more!

ASKING PRICE $5000

Will post current pics soon.

Summary of Motorcycle:

Suspension
Forks were redone and optimized by Ed Sorbo of Lindemann Engineering (Ed also added fork drains at the bottom of the forks so I can do oil changes w/o removing the forks.)
SSR Preload caps
Penske triple with LE valving and short reservoir hose (will mount to battery box)
Springs front and rear are based on my weight and riding style.
2010 Aluminum shock triangle for less weight!
SSR preload caps

Ignition
BRT-is
NGK CR8EIX plugs
Takai Racing Coils

Engine
APE Ported head with +1.5mm intake valves
APE custom springs
New guides, seals and retainers
Falicon ultra light crank mods
Falicon gram matched, shot peened and polished rods with bronze bushings
JE 13.5:1 pistons +2mm
BEET cams both intake and exhaust
newer cam chain
newer cam chain tensioner
ISF polished transmission gears
Worldwide ceramic transmission bearings
Custom SS oil line
Newer water pump and hoses
Nikasil cylinder coating
Thermobob 3
Engine EGR block off plates
Lots of new seals, gaskets and consumables

Fuel/Intake
CR31 carbs full complement of jetting
Ported stock airbox
heat shield added to rear of engine for cooler air
heat shield added to underside of gas tank

Exhaust
Leo Vince carbon superbike exhaust with custom header flanges that perfectly match the head and pipe for superior flow (I don't need to use gaskets). Pics elsewhere
NGK A/F ratio gauge installed

Frame and Controls
Motion Pro VR Throttle (50mm cam)
Motion Pro Right Cluster Switch
Heated Grips
WC Clip-ons
Stainless bolts where I could easily replace
Aluminum gas cap bolts, full aluminum race spec engine kit from ProBolt, AL sprocket nuts, TI brake bolts, TI oil drain bolt
Lightech Rearsets
Ohlins damper with BEET mount

Brakes
@rojoracing53 modified rear brake rotor (shaved off 13 oz or so!!!)
@rojoracing53 modified rear brake hanger (captive)
Braking full floating front rotor
Vesrah SJRL front pads
SS brake lines (both custom)
Brembo RCS15 radial master, reservoir, and custom bracket
Rear reservoir delete

Other Fun Stuff
Newer tires
MicroBlue Ceramic Wheel Bearings
New sprockets with a 520 non-oring chain (15/43)
Engine Ice high performance coolant (no mixing)
Yoshimura Fender eliminator
Fully safety wired past WERA/AMA specs
Kawasaki DB windscreen
Spears Racing Chain Holder
Battery Tender
Super Bright Full LED tail light
Captive front wheel spacers (eliminates speedo)

Probably more that I am missing. Truly a sight to see!!!
mgentz is offline   Reply With Quote