View Single Post
Old August 15th, 2012, 08:01 PM   #11
waffles666
ninjette.org member
 
Name: Nick
Location: Adelaide
Join Date: Aug 2012

Motorcycle(s): Ninja 250R 2011

Posts: 10
Quote:
Originally Posted by CC Cowboy View Post
What part of the bike are you "breaking" when the engine stops?
I'm using the front break and a little of the rear.

Quote:
Originally Posted by dubojr1 View Post
So light braking is fine?

Pull the air filter and verify the airbox is empty/clean. Check the filter while your there. Reference the photo's here for snorkel location and air filter removal.

http://www.ninjette.org/forums/showthread.php?t=10090
Just pulled it out and the airbox and snorkel are both empty and the filter looks near new, probably replaced at last service. I assume the clear oil the filter is covered with is normal?

Quote:
Originally Posted by DaBlue1 View Post
Set your idle speed to 1500 after the bike is fully warmed. With the choke fully on, the idle speed should increase close to 3k while warming up.
Idle speed is bang on what you are describing. I returned it to these settings a couple of days ago because I normally run it at about a 1,750 idle is this bad for the motor?
waffles666 is offline   Reply With Quote