|
Oh I forgot a list of tools I needed to take the engine out.
-Allen Key Set Metric
-Socket Set Metric (I used 10mm 12mm 2x14mm 17mm and 24mm (rear Wheel))
You need a second Wrench of breaker bar to hold the bolt in place when removing the 2 rear engine mount nuts hence the need for 2 14mm sockets
-Phillips head screw Driver for disconnecting hoses and carbs
-Crescent wrench for adjusting clutch and throttle cables to get them disconnected
-A jack to lower the motor
-An afternoon to do it
-Libations for your post engine remove celebration
|