View Single Post
Old May 3rd, 2012, 11:28 AM   #15
kycycles
ninjette.org member
 
Name: adam
Location: kentucky
Join Date: Nov 2009

Motorcycle(s): 08 ninja 250

Posts: 51
Quote:
Originally Posted by alex.s View Post
better if you have an oscilloscope but, hook the multimeter up to it on voltage and crank it. see if you get voltage readings from the pulser coil while it cranks.

you tested the coils how? just ohms check? did you check for voltage going into the coils?

if you are getting power to the coils, check the engine ground toward the back near the starter motor. if the case isnt grounded properly it obviously wont spark

i dont see the ground right off. from where to where should that be running?
kycycles is offline   Reply With Quote