Quote:
Originally Posted by gamma500
Would you share the name of the supplier and did you happen to locate there the connector part #'s that would plug into the older CDI's ?
|
Sure, I don't mind sharing. Here's the info:
You need the two connectors shown side by side in the lower part of the above picture, along with 8 pin male sealed connector previously pictured, which is available here:
http://www.easternbeaver.com/Main/El...FKWH/fkwh.html
The owner of Eastern Beaver also said the following connectors are the same as the ones pictured above (from the '88-94 harness):
Those are 4 and 6PF250 connectors.
http://easternbeaver.com/Main/Elec__...onnectors.html
I decided not to purchase the 4 and 6PF250 connectors, as it looked like they didn't lock the same way the original's do. They need to lock on the old CDI, not vice versa!
Rather than spend $60 for the crimper tool to do the round sealed connectors from Eastern Beaver, I ordered the $16 crimper pictured here:
http://www.oregonmotorcycleparts.com/connectors.html
The owner of Oregon Motorcycle told me that he has used the $16 crimper successfully on round connectors. It will also work on all the other connectors used on the Ninja!
FYI, as recently as this afternoon there are still used '88-94 harnesses available as low as $18.95 and CDIs, also.