Quote:
Originally Posted by ducatiman
So moving forward.... @ blanzer you posted you checked/set your valves early on in the thread. At what spec?
Factory spec is 0.003-0.005 inches for the intake valves and 0.004-0.006 inches for the exhaust valves. Exactly where are yours set?
|
I always aim for the looser end so I don’t have to do it as often. I suppose I can check them again just to be sure. I’ll check them out later today. I don’t have the super accurate feeler gauges I have the ones with a range on them, so for .005 on the intake I use the .005-? And if that fits, then I use the .006-? And make sure that doesn’t fit. Might be putting them too loose perhaps?