January 1st, 2022, 09:11 PM | #1 |
Guest
Posts: n/a
|
Need a Windscreen for my 1986 Ninja 250
Been searching high and low for a windscreen for my 1986 Ninja 250 but I cannot seem to find one. The only ones that I can find are for the 1988 and up models of the Ninja 250. Is it possible to use one of those or there other options for this?
Thanks Tom |
|
January 1st, 2022, 11:52 PM | #2 |
ninjette.org certified postwhore
Name: AKA JacRyann
Location: Mesa, AZ
Join Date: Dec 2011 Motorcycle(s): CB125T CBR250R-MC19 CBR250RR-MC22 NSR350R-MC21 VF500F CBR600RR SFV650 VFR750F R1M ST1300PA Valkyrie-F6C Posts: A lot.
MOTY - 2018, MOTM - Nov '17
|
Yes! It's possible to use windscreen from '88-07 pre-gen on '86-87 1st-gen. Here's an '87 I rescued in boxes.
Put it all back together Ended up using headlight, windscreen and mirrors from pre-gen. Bolt upper holes together and you'll see lower holes don't quite line up. I marked from back side where to drill new hole in windscreen to fit. Thinking back, I should've marked from front and drilled new hole in fairing. Then final result would've been cleaner without unused original hole in windscreen visible. Last futzed with by DannoXYZ; January 2nd, 2022 at 08:34 AM. |
|
January 2nd, 2022, 03:33 PM | #3 |
Guest
Posts: n/a
|
OK, thank you for the info I that. How does it work to block the wind and cut down on the wind noise going through the helmet?
Thanks Tom |
|
January 2nd, 2022, 05:22 PM | #4 |
ninjette.org certified postwhore
Name: AKA JacRyann
Location: Mesa, AZ
Join Date: Dec 2011 Motorcycle(s): CB125T CBR250R-MC19 CBR250RR-MC22 NSR350R-MC21 VF500F CBR600RR SFV650 VFR750F R1M ST1300PA Valkyrie-F6C Posts: A lot.
MOTY - 2018, MOTM - Nov '17
|
works pretty well. I bought taller "double bubble" screen that's about 2" taller.
Good article on this bike: http://www.yeoldecycleshoppe.com/roa...250r-road-test |
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1986 ninja 250 | james250ninja | Pictures | 12 | August 19th, 2014 05:58 AM |
|
|