August 9th, 2012, 07:57 PM | #2 |
ninjette.org sage
Name: Karl
Location: MA
Join Date: Jun 2012 Motorcycle(s): 2000 Kwak Ninja 250 and 1998 Yamaha YZ400F Posts: 534
|
Underneath a plug. I would use a center punch to make a mark in the plug. drill a hole slightly smaller than a small sheet metal screw. Thread the screw into the plug a few turns so that it will hold when you pull on it with pliers.
Here's pictures. http://faq.ninja250.org/wiki/Removin...re_screw_plugs |
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY - Accessing and adjusting idle mixture screws | VeX | 2008 - 2012 Ninja 250R Tech Talk | 71 | December 15th, 2017 03:38 AM |
adjusting idle mixture screws | james250ninja | 1986 - 2007 Ninja 250R Tech Talk | 9 | September 1st, 2014 10:29 AM |
air/mixture screws factory setting | jgcable | 1986 - 2007 Ninja 250R Tech Talk | 1 | July 30th, 2014 07:19 AM |
Awesome tool for adjusting mixture screws - with both fairings on! | headshrink | 2008 - 2012 Ninja 250R Tech Talk | 6 | December 5th, 2011 05:14 PM |
Enrichening the Fuel Air Mixture? | Scattcatt | 2008 - 2012 Ninja 250R Tech Talk | 28 | September 22nd, 2011 06:27 PM |
|
|