Clip On Bar Question

PicosKun · January 28th, 2014, 10:42 AM

Was thinking of getting these Clip-On. Anyone have these? are they good and what else would I need to get these on? I screwed up my left bar. I have a 2012 ninja ex250

bkh2 · January 28th, 2014, 10:58 AM

If you mount those below the triple, it will interfere with the gas tank. I dropped the front end by ~0.75 inches such that I could mount the clip-on above the triple, and the clearances were perfect. If those have adjustable angles, the mechanism that locks the angle in place is not robust. Just be wary of how much torque you apply to it. Furthermore, the bars have pre-drilled holes into which the controls enclosure clamps, but I found them to be too far out. That is, if you use the predefined placement, the grip will stick out by like 1.5".

PicosKun · January 28th, 2014, 11:01 AM

thanks

January 28th, 2014, 10:42 AM	#1
PicosKun ninjette.org member Name: Aldo Location: Inglewood Join Date: Dec 2012 Motorcycle(s): 2012 Ninja ex250 Posts: 12	Clip On Bar Question Was thinking of getting these Clip-On. Anyone have these? are they good and what else would I need to get these on? I screwed up my left bar. I have a 2012 ninja ex250

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
clip ons and bar ends	subxero	2008 - 2012 Ninja 250R Tech Talk	5	February 23rd, 2014 11:12 AM
Left SV650 Clip On Handle Bar (DIY Clip On NewGen)	shiftdrift06	Motorcycle-related	26	October 25th, 2012 08:46 PM
Help WC clip ons adding bar ends	Shaol1n Monk	2008 - 2012 Ninja 250R Tech Talk	10	July 22nd, 2011 05:57 AM
Bar End Weights For Clip-Ons??	stealth250	2008 - 2012 Ninja 250R Tech Talk	11	June 14th, 2009 10:54 PM

January 28th, 2014, 10:58 AM	#2
bkh2 ninjette.org guru Name: Ben Location: R'lyeh Join Date: May 2011 Motorcycle(s): 2006 GSXR 750; 1983 CB750SC Posts: 277	If you mount those below the triple, it will interfere with the gas tank. I dropped the front end by ~0.75 inches such that I could mount the clip-on above the triple, and the clearances were perfect. If those have adjustable angles, the mechanism that locks the angle in place is not robust. Just be wary of how much torque you apply to it. Furthermore, the bars have pre-drilled holes into which the controls enclosure clamps, but I found them to be too far out. That is, if you use the predefined placement, the grip will stick out by like 1.5".

January 28th, 2014, 11:01 AM	#3
PicosKun ninjette.org member Name: Aldo Location: Inglewood Join Date: Dec 2012 Motorcycle(s): 2012 Ninja ex250 Posts: 12	thanks