[2fiddy.com] - “No Cut” Brake Modulator

[Ninjette Newsbot]

A while back we talked about the BackOff brake Modulator/Flasher but it does require a few wires to be cut for installation. Some crafty 2Fiddy’r has come out with a much less expensive option, that is also ‘No Cut’ installation.. (Can we say WIn-Win) Meaning it’s “Plug and Play”… So You can put away your soldering irons, butt plugs, and electrical tape and run right out and flash your neighbors.. (Whoa.. That can be taken a few different ways…) This no cut model is based off the Rear-Alert module, and installation should take no more than “2 minutes”..

So for those of you asking, ‘What exactly is a Brake Modulator, and why do I want one?” — Well it’s simple:

When your front or back brakes are applied, the modulator pulses your brake lamp for about 4 seconds. The lamp then stays on solid until you release the brakes. Re-applying the brakes causes the unit to pules the brake light an additional 4~5 seconds. Generally you get 7 or 8 pulses before the lamp stays on solid. Also, cutting the green wire doubles the flash time should you want your brake light to flash longer.

Remember, Visibility is key when it comes to safety when on a bike.

Price: $19.95
URL: EBay Motors

Click here for full story...