November 19th, 2018, 03:26 PM | #1 |
ninjette.org member
Name: Mauricio
Location: Mexico City
Join Date: Aug 2015 Motorcycle(s): 250R Posts: 86
|
Rear Hub Question
Hello!!!
I have just bought a 300 rear wheel for my 250 to get that extra 1/2 inch but it does not have Rotor or Hub. I know my current rotor will fit but a have not been able to find any info about the hub. Will my 250 hub fit in the 300 wheel?? Any info will be really appreciated. |
|
December 1st, 2018, 04:46 PM | #2 |
ninjette.org member
Name: Mauricio
Location: Mexico City
Join Date: Aug 2015 Motorcycle(s): 250R Posts: 86
|
Update.
Just to let you all know that the rear hub from a 250r does fit a 300 rear wheel.
Every thing is working great and the 150 tire looks a lot better in the 4" width rim. Not so "curved" Regards |
|
December 2nd, 2018, 04:39 PM | #3 |
ninjette.org certified postwhore
Name: AKA JacRyann
Location: Mesa, AZ
Join Date: Dec 2011 Motorcycle(s): CB125T CBR250R-MC19 CBR250RR-MC22 NSR350R-MC21 VF500F CBR600RR SFV650 VFR750F R1M ST1300PA Valkyrie-F6C Posts: A lot.
MOTY - 2018, MOTM - Nov '17
|
Not sure what you mean by rear-hub vs. rear-wheel....
Hub is centre section that axle goes through. Contains bearings. Wheel.... is typically hub + rim. On these Ninjas, hub + rim is one-piece combo. So 250R hub is part of 250R wheel and cannot be separated. And a 300 hub is part of 300 wheel and cannot be separated. It's not possible to use 250R hub with 300 rim, or vice-versa, unless you cut off rim and weld it onto spokes of other wheel. |
|
December 2nd, 2018, 05:11 PM | #4 | |
ninjette.org member
Name: Mauricio
Location: Mexico City
Join Date: Aug 2015 Motorcycle(s): 250R Posts: 86
|
Quote:
I'm sorry... I think I used the wrong name... The part I am referring to is the COUPLING-ASSY, RR HUB with the following part numbers: 250R 42033-0030 300 42033-0574 Hope this helps someone in the future. |
|
|
December 2nd, 2018, 07:29 PM | #5 |
ninjette.org certified postwhore
Name: AKA JacRyann
Location: Mesa, AZ
Join Date: Dec 2011 Motorcycle(s): CB125T CBR250R-MC19 CBR250RR-MC22 NSR350R-MC21 VF500F CBR600RR SFV650 VFR750F R1M ST1300PA Valkyrie-F6C Posts: A lot.
MOTY - 2018, MOTM - Nov '17
|
Ahh.. I true, that part can be called "Rear Wheel Drive Sprocket Mounting Hub". I usually use sprocket-carrier, fewer words! Yes, they do interchange between pre-gen 250, new-gen 250R and 300. I got set of hollow 6/4 titanium studs and saved about 300gm from rear wheel!
|
|
December 2nd, 2018, 09:10 PM | #6 |
ninjette.org member
Name: Mauricio
Location: Mexico City
Join Date: Aug 2015 Motorcycle(s): 250R Posts: 86
|
Thanks!!!
|
|