June 20th, 2011, 12:30 PM | #1 |
ninjette.org user
Name: Brandon
Location: Quincy, Ma
Join Date: May 2011 Motorcycle(s): 2010 Ninja 250r (Blue) Posts: 24
|
Front brake bore size?
Hi everyone. I'm buying a custom lever system for my 2010 Ninja 250r because of a disability I have. I will have both the front brake and clutch lever on the right side of the bike. The company I'm trying to order the parts from today asked me a couple specific questions. Unfortunately the motorcycle shop I bought my bike from and currently has my bike, is closed on Mondays. I hope someone here might know/verify the answer to these.
Q: Bore size of front brake master cylinder? A: 62.0 x 41.2mm Q: Is it a hydraulic clutch? A: No, cable-actuated Q: Assuming it is a cable clutch; is it nipple or lasso? A: From the 'DIY Replacing the clutch cable' thread for changing a clutch cable, doesn't look like anything is lasso'd so going to say nipple Q: Assuming it is a cable clutch; what is the distance between the lever pivot point and center of nipple/lasso? A: Again looking at the DIY, there was a convenient picture of the lever with a ruler by it. It looks like 20-30 mm. Thank you for the help. ~Brandon Last futzed with by theredsox; June 20th, 2011 at 03:42 PM. Reason: Think I found the answers |
|
June 20th, 2011, 03:44 PM | #2 |
ninjette.org user
Name: Brandon
Location: Quincy, Ma
Join Date: May 2011 Motorcycle(s): 2010 Ninja 250r (Blue) Posts: 24
|
I think I found all the info I needed from the 'DIY Replacing the clutch cable' thread. Would be comforting to have confirmation though as I currently don't have my 2010 ninja yet to look at or the manual. Spending $1500 and getting the part from England, so really want to make sure it is right the first time.
|
|
June 21st, 2011, 01:53 PM | #3 |
IC2(SW)
Name: Kerry
Location: Pensacola
Join Date: Nov 2008 Motorcycle(s): . Posts: A lot.
|
|
|
June 21st, 2011, 03:00 PM | #4 |
ninjette.org user
Name: Brandon
Location: Quincy, Ma
Join Date: May 2011 Motorcycle(s): 2010 Ninja 250r (Blue) Posts: 24
|
Thanks HKr1. The 62 x 41.2 I saw is probably engine cylinder and not what I want. 14 and 16mm sounds realistic.
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Smallest possible front sprocket size | SvenW | 2008 - 2012 Ninja 250R Tech Talk | 2 | August 22nd, 2013 05:54 AM |
Front Master Cylinder Size | FvnnyL3tt3r1ng | 1986 - 2007 Ninja 250R Tech Talk | 3 | August 14th, 2013 02:38 PM |
Front caliper bolt size | Vergil | 2008 - 2012 Ninja 250R Tech Talk | 3 | June 16th, 2013 05:35 AM |
Front brake master cylinder piston size | old3 | General Motorcycling Discussion | 3 | November 16th, 2012 03:39 PM |
What size ratchet to take off front sprocket? | M-Oorb | 2008 - 2012 Ninja 250R Tech Talk | 15 | January 12th, 2009 02:42 PM |
|
|